Vibrating screen is a machine used for ore screening. There may be some problems in the use of vibrating screen. What causes the poor screening quality of vibrating screen? 1. Mesh clogging When the mud content and water content in the feed are high, the material will stick to the screen hole and block the screen hole. At this time, the screen hole shall be cleaned first, and then the water spray amount and the screen surface inclination shall be adjusted appropriately. 2. The sieve hole is severely worn When the screen is used for a long time, the mesh will be seriously worn and the screening effect will be seriously affected. At this time, the worn mesh shall be repaired. When the wear is serious, the mesh shall be replaced. 3. Uneven feeding of sieve When the feeding groove of the screen is too narrow, the material can not be evenly distributed along the whole screen surface, so that the screen surface can not be effectively used, and the screening effect will be affected. At this time, the width of the feeding chute shall be adjusted to make the feeding of the sieve uniform. 4. The material on the screen is too thick The material on the screen is too thick, which may be caused by the larger feeding amount, the blockage of the screen hole, the small inclination of the screen surface, etc. At this time, it should be adjusted according to the specific situation.
Copyright：Linqu Huazhong Jixieshebei Co.,Ltd. Add：Weifang, Shandong Linqu Economic Development Zone Technical support：Seahigh Network
phone：13455690699 tel：086-0536-3450699 fax：086-0536-3472569 E-mail：sdjx1314@163.com
