Crushing production line vibrating feeder installed in three cases: Horizontal mounting.This bell installation for materials in general uniform and stable feedstock.It can prevent the gravity of the material. Downwardly inclined 10 degrees.This installation is suitable for continuous feed materials. Downwardly inclined 15 degrees.This installation is suitable for viscous or moisture content of the larger material continuous feed. The vibrating feeder run should pay attention to the situation: Before running should all bolts once and especially vibration motor, anchor bolts, 3-5 hours continuous operation should retightening. Two vibrating motors must run reverse rotation.If the current unstable or noise was very loud, should stop immediately. The maintenance of vibrating feeder: Regular checks of the amplitude of the vibration motor, such as unusual situation, should be shut down immediately. This is because the amplitude evenly around the the vibration motor current and motor surface temperature requirements, not left and right swing shake. Motor bearing is a the entire crushing production line vibrating feeder mouth key equipment, so its maintenance is also particularly important. The lubricant filling once every two months under normal conditions, the hot season should be filling the oil every month. And every six months motor should re overhaul, the internal bearings should be replaced.
Copyright：Linqu Huazhong Jixieshebei Co.,Ltd. Add：Weifang, Shandong Linqu Economic Development Zone Technical support：Seahigh Network
phone：13455690699 tel：086-0536-3450699 fax：086-0536-3472569 E-mail：sdjx1314@163.com
